Hacking MAC Address Spoofing With Macchanger In Kali Linux


MAC address spoofing is a technique for temporarily changing your Media Access Control (MAC) address on a network device. A MAC Address is a unique and hardcoded address programmed into network devices which cannot be changed permanently. The MAC address is in the 2nd OSI layer and should be seen as the physical address of your interface. Macchanger is a tool that is included with any version of Kali Linux including the 2016 rolling edition and can change the MAC address to any desired address until the next reboot. In this tutorial we will be spoofing the MAC address of our wireless adapter with a random MAC address generated by Macchanger on Kali Linux.

MAC Address Spoofing
First we need to take down the network adapter in order to change the MAC address. This can be done using the following command:

ifconfig wlan1 down
The ifconfig tool will be replaced by iproute2. Use the following command to take down wlan1 with iproute2:
ip link set wlan1 down
Replace wlan1 with your own network interface.
Now use the following command to change your MAC address to a new random MAC Address:
macchanger -r wlan1
As shown on the screenshot, Macchanger will show you the permanent, current and changed MAC address. The permanent MAC Address will be restored to your network adapter after a reboot or you can reset your network adapters MAC address manually. Use the following command to restore the permanent MAC address to your network adapter manually:
macchanger –permanent wlan1
You can also spoof a particular MAC address using the following command:
macchanger -m [Spoofing MAC Address] wlan1
macchanger -m XX:XX:XX:XX:XX:XX wlan1
If you receive the following error you need to take down the network interface first before changing the MAC Address (Command: ifconfig wlan1 down):
ERROR: Can’t change MAC: interface up or not permission: Cannot assign requested address
Use the following command to bring up your network adapter with the new MAC address:
ifconfig wlan1 up
Or use the following iproute2 command to bring the wlan1 device back up:
ip link set wlan1 up
Use the following command to show the current MAC address:
macchanger –show wlan1
 
Top Bottom